Ducati 899 Panigale Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter · #1 ·
Bought a pre-owned set of Marchesini M10RS Kompes. The rear only had one spacer, the sprocket side. I popped in the OEM space from the disc side and found the total width is still about a half inch less than needed. Inside swingarm measures right at 9.5 inches and the Marchesini w/OEM disc side spacer measured 9.0 inches. OEM set measures 9.5 in width as well.

Any ideas on sourcing the rear disc side spacer needed? Disc lines up no problem, just a half inch gap from spacer ti swingarm.

Thanks,
KD


Sent from my iPhone using Tapatalk
 
1 - 2 of 2 Posts
Top