|Topic Review (Newest First)|
|07-21-2019 03:31 AM|
Well done old boy!
Nice to kick a goal once in a while
|07-20-2019 11:41 AM|
All fixed! It was the sensor on the exhaust under the seat.
Had to lift the subframe up a bit to get better access to it and then remove the black side panel bits and the ECU fairing to sort the cable out.
Took me a few hours but very satisfying to have done it myself rather than £190 part + labour!
The faulty sensor looked perfectly fine, the wire and the plug looked perfect, guess it had just failed internally.
|07-17-2019 05:33 AM|
I'm sorry I should have read you post properly, if it's been diagnosed as vertical then there you go.
Good luck with it and let us know how you go.
|07-17-2019 04:02 AM|
Thanks for the support
It's sensor 1 of "bank 2" though which I think is the vertical cylinder? Once the new sensor arrives I'll play with the plugs and see which one it is for sure.
|07-16-2019 06:20 PM|
It's not as bad as you think but yes tank and subframe will make it easier as well as right mid fairing.
But in saying that is sensor 1 not the front cylinder? sorry I have my fairings on at the moment so can't check. But if that's the case you won't need to lift the subframe just the side fairing, you might have to google it.
|07-16-2019 07:15 AM|
|Grimson||I have now bought a new sensor so can troubleshoot which is the faulty one. Going to be a right pain doing the one under the seat, looks like I have to lift the tank and subframe to get it out!|
|07-15-2019 04:30 PM|
|sdg24||I think your best bet is just to replace the sensor. I’m not familiar with the sensor locations to tell you which one is correct for your code though.|
|07-15-2019 06:17 AM|
2015 899 Check Engine Light after start up
Wondering if anyone can assist please.
My bike is throwing a CEL after start up, within the first few minutes of running. The bike doesn't go into limp mode but says Engine Error in the menus.
If I then turn the ignition off and on again and start it up it doesn't come back on and I can ride for a full tank of fuel without any issues at all.
I've had the dealership plug it in and the code that comes up is P0150 which seems to relate to an O2 sensor. I am told it's Vertical Cylinder one but not sure if that is correct? Would that be the one under the seat or down on the side pipe?
When I google it comes up with things like "P0150 code definition O2 Sensor Circuit Malfunction (Bank 2 Sensor 1)"
I have the Termi exhaust and Up-Map
Although the bike runs totally fine I'd obviously like to get it sorted. Any suggestions of things to try before I spend £190 on a new sensor and fitting at the dealership.