I was out riding and after I stopped to get gas I was not able to shift up from 1st and couldnt find neutral, it was stiff like I had already reached 6th. I pulled over to inspect and found that the bolt holding the quickshifter was very loose and close to falling off. I hand tighten the bolt the best I could and rode back home. I am not sure how to properly get access to tighten down the bolt as the clutch slave cylinder is in the way. What is the best approach for this? Do I remove the otherside of the quickshifter that is connected to the shift lever on the rearset to get some clearance? If so, please instruct me how I remove that. I have the Lightech Rearsets.